• A team of highly experienced, degreed engineers and technicians
• ProE solids modeling software
• AutoCad Software
• Extensive experience in direct 3D prototype and tooling
• 14,000 sq-ft mechanical and vehicle technology Center
• 1,500 sq-ft electronics technology lab

• High performance test vehicles including early and late models
• Testing to EPA 75, Euro Stage I and Stage II cycles
• 1000 HP chassis dyno for performance
• 200 HP motorcycle dyno
• Local access to full NHRA quarter mile track facilities

Engine Dyno Systems

• 1000 HP SuperFlow dyno with full data acquisition
• Fuel, air, temps, and pressure measurement
• 3 independent fuel systems for a variety of testing
• Over 20 sample test engines up to 1500 HP
• DTS engine dynamometer 2000 HP

• Largest wet-flow bench in the U.S. (6000 cfm)
• Computerized master laminar wet-flow stand
• Cylinder head flow bench
• Camshaft measurement and analysis

• Fuel injector performance test system
• Fuel pump and regulator test stand, computerized
• Fuel pump durability test stands

• Fully equipped machine shop including
• Lathes
• Injector lathe
• Milling machine
• Drill presses
• Surface grinder
• Band and cutoff saws
• Optical comparator
• MIG welder

• Thermotron environmental chamber (-40F to 400F)
• 3 distributor performance test stands
• Mil spec vibration table
• Variety of digital and storage oscilloscopes
• HP logic analyzer
• HP EMC field analyzer

• Viewlogic schematic capture software
• PADS PCB layout software
• SPECTRA autorouter software
• TANGO circuit analysis software

• Labview nitrous data acquisition system
• Labview water pump performance test stand
• Labview fuel pump test stand