Skip to main content
ASK OUR EXPERTS
1-866-464-6553
Holley Sniper EFI

400 LPH Fuel Pump Assembly

Replacement 400 LPH FUEL PUMP AND HANGER ASSEMBLY

Part # 19-168 Be the first to write a review

400 LPH Fuel Pump Assembly

In Stock
Free Shipping - Lower 48 US States
$393.95
Add to Wishlist
Starting at $35 a month with Learn More
4

Emissions

This part is legal for sale or use on Racing Use Only Vehicles

The following vehicles are considered Racing Use Only Vehicles:

  • Racing Use Only Vehicles are vehicles that are used exclusively for competition that are not registered and that may never be used on the street.

    See Emissions Details
400 LPH Electric Fuel Pump Assembly for Sniper EFI Fuel Tanks. Oven brazed fittings can withstand 100 psi. Genuine Walbro Fuel Pump included. 1/4" NPT Supply and Return line. For a better seal use Permatex Indian Head Gasket Shellac Compound or Aviation Form-A-Gasket sealant on the gasket and screws.

Features:

  • 1/4" NPT Supply and Return Line
  • In-Tank Wire Harness
  • Made in USA
  • Heavy 10 gauge no-warp mounting plate
  • Barbed Vent Fittings
  • Up to 100 PSI
  • New Mounting Screws and gasket available separately
Brand Holley Sniper EFI
ColorGold
Emission Code4
5
FinishGold Iridited
Fuel TypeGasoline
MaterialSteel
Product TypeFuel Pump
WarrantyLimited 90 Day
UPC090127003527
Part Number19-168
4

This part is legal for sale or use on Racing Use Only Vehicles

The following vehicles are considered Racing Use Only Vehicles:

  • Racing Use Only Vehicles are vehicles that are used exclusively for competition that are not registered and that may never be used on the street.

WARNING: It is against the law to install this part on an Emissions Controlled Vehicle

New Mounting Screws and gasket available separately. *19-170 kit is a thicker gasket and longer screws for use on the GM A Body (Chevelle, GTO, etc....) fuel tanks since they are shallower at the point where the fuel pump is mounted. *19-169 kit for all other EFI fuel tanks Connect your in-tank wire harness to the fuel pump, making sure that the connections are secure. Route the wires through the pass through fitting being sure to leave a little slack to prevent strain or chaffing, Use a 9mm wrench to tighten the upper jam nut on the wire pass through in 1/4 turn increments until the wire no longer moves up and down. BE CAREFULL NOT TO OVERTIGHTEN DOING SO COULD BREAK THE FITTING OR CAUSE A LEAK.
Limited 90 Day: See Details
Reviews

    Your Review

    *Free Shipping & Handling only offered to the contiguous US on orders over $149, excludes clearance parts and oversized packages.

    Some parts are not legal for use in California or other states with similar regulations.