632 CID Race Engine Makes 1261 HP with Holley 1250 Ultra Carb
Steve Furr of Furr Motorsports, a 2009 NHRA Division 2 Top Dragster champion, is in the process of dyno testing his 632 cubic inch big block built by PAR Racing Engines in Spartanburg, South Carolina. The engine was just tested using Holley's 1250 Ultra Carburetor and managed to pull 1261 horsepower at 7200 rpms. “The new Holley Ultra 1250 carb jetted up to 100, made the same horsepower as my old tricked out carb did…and with only an intermediate and main jet changes. Nothing else.” says Furr.
The 632 uses Brodix 12-degree aluminum heads, intake and aluminum block. It's outfitted with JE pistons, a Milodon oil pan and gear drive, Manley steel rods and Holleys Ultra 1250 cfm carburetor. According to Furr, it’s the most powerful engine PAR has made using a single carburetor. “The engine will be placed in a 2011 240" American Racecars swing-arm dragster, says Furr. “The carb is very responsive and makes good power and torque. It’s also extremely light weight. This is definitely going to be a good piece!”
Furr is also a five-time IHRA AllStar and Divisional Champion, as well as a three-time IHRA World Champion and two-time IHRA Sportsman Drive of The Year.
Holley Announces Sponsorship of Danchuk Tri-Five Nationals| 02/20/2015
Holley is proud to be a part of the inaugural Danchuk Tri-Five Nationals, which will be held at Beech Bend Raceway in Bowling Green, KY on August 14-15. Read on for more details and information about the event!
Jeremy Stoermer's AAR Cuda Tribute Car| 02/06/2015
Our very own Jeremy Stoermer was kind enough to share his jaw-dropping 1970 AAR Cuda Tribute car with us. Check out our video to learn more about the car, the story behind it, and to hear that 340 cubic inch Mopar-mill roar!
Hot New XDR Off-Road Competition Exhaust for Polaris RZR XP1000| 06/18/2019
In this video you will get to hear the deep powerful sound of the hot new XDR Off-Road Competition exhaust system for 2015-17 Polaris RZR XP1000 EPS 2/4 door models.
How to flip Racepak G-Meters| 06/18/2019
When mounting a Racepak data logger there are specific mounting instructions that are needed to be followed in order for proper G-Meter readings. But what if those mounting instructions won't work in your application?