This Carburetor Bushing Kit reduces the 1/2 inch throttle shaft hole to 1/4 inch i.d., (inner diameter) which makes for easy throttle linkage attachment, or can be used to replace the stock rubber unit. Machined from cold roll steel, then bright zinc plated, the two piece bushing measures 9/16 inch wide when installed and fits most 4-barrel carburetors with 1/2 inch throttle linkage hole. Application: All GM (General Motors) and most Holley Carburetors with 1/2 inch diameter throttle hole.
1/4" Inside Diameter - fits 1/4" Bolt
Fit Throttle Linkage w/ 1/2" Hole
Throttle Lever Bushing
Limited 90 Day
This part is legal for sale or use on Emissions Controlled Vehicles, Uncontrolled (Non-Emissions Controlled) Vehicles, and Racing Use Only Vehicles because it does not affect vehicle emissions and is not covered by emissions regulations.