Holley's Truck Avenger series carburetors have just been taken to the next level. Truck Avenger carburetors are known to go off-roading right out of the box, so what could be better than a Holley Truck Avenger™ carburetor? How about one in aluminum? They save weight and look great. The Aluminum Truck avenger features a chromate finish to protect against the grueling environments encountered by an off-road vehicle.
The Aluminum Truck Avenger is designed specifically for off-road applications. The unique fuel metering block eliminates fuel spillover through the boosters at extreme angles allowing for 40 degree climbing, 30 degree side hill maneuvers and nose-down descents to avoid hesitations, stalling and flooding typically associated with carbs in an off-road environment.
The Aluminum Truck Avenger carburetors have the same great features as their zinc counterparts such as a quick change vacuum secondary for easy fine tuning; four vacuum ports for all necessary vacuum accessories; manual choke for precise cold start control; and a built-in fuel filter.
The 770 CFM Off-Road Truck Avenger is the perfect carburetor for big block engines.
Features:
Aluminum Construction for added weight savings
Gold Dichromate finish for extreme off road environments
Single feed fuel inlet for ease of installation
Optimized off-road calibration that works out-of-the-box
Manual choke (Cable driven, hand operated) for precise cold start control
Vacuum secondaries allow use on a wide variety of vehicles. Quick Change vacuum housing cap allows you to tune for performance or fuel economy (springs included)
Compatible with GM, Chrysler, and Ford A/T kickdown linkage. Additional parts may be required.
One piece off-road vent tube eliminates fuel spillover during extreme maneuvers
Intended for off-road/off-angle use. Unique metering block designed for flood free operation up to 40º while climbing and 30º during side hill maneuvers & “nose down” decents
Limited lifetime warranty - Guaranteed to be free from defects in material and workmanship for the life of the product!
100% wet-flow tested by Holley technicians to assure it arrives ready to run!
This model of carburetor has the square bore flange bolt pattern. It can replace Holley, Edelbrock, Carter AFB, and Autolite style carburetors with 5 3/16" x 5 5/8" bolt pattern. If you have a spreadbore style intake manifold, you will need an adapter to install this carburetor. Similar to the Mr. Gasket #1932.