Bright Earth Heavy-Duty LED Work Lights
If you’re looking to light your work truck bed, have some extra lighting alongside your race trailer, or gain some extra visibility when on the trails or any other off-road application, look to the Bright Earth Heavy Duty LED Work Light. With its combination of protection and durability, these may be just the compact, easy-to-install lights you’ve been looking for. And they’ll make looking for everything else a breeze on those dark nights.
Featuring thirty-three Light Emitting Diodes putting out an impressive 726 lumens total, Bright Earth Heavy Duty LED Work Lights only draw 0.3 Amps at 13.8 volts, making them ideal for car trailers, UTV’s, truck beds, golf carts and more. And they’re built to be durable in the toughest off-road environments, too, with a die cast housing and mounting bracket, as well as a unique waffle design lens. Equipped with a waterproof pigtail connector, stainless hardware, and being IP67-rated, you can rest assured that dust and weather won’t be an issue.
The Bright Earth part number WRKL1-BEL Heavy Duty LED Work Light shown here is a flood light, meaning that its 120-degree beam pattern will illuminate a larger amount of space than a spot light, using the same wattage and lumen output. At 6.6 watts, the thirty-three CREE .2 watt-each LED’s provide a bright 6000K crystal white light, and operates on any input voltage from 10-30 Volts DC.
Ideal for compact installations, the Bright Earth Heavy Duty LED Work Lights are only 3-5/8 inches wide by 3-inches tall and 3/4 of an inch deep, and the black-finish housing will complement nearly anything without becoming the focal point. With the mounting bracket located on the bottom, placement options are nearly endless, and the simple two-wire pigtail with reverse-polarity protection makes installation nearly foolproof.
How to Choose a Street Ignition| 01/04/2019
We all know the basics of how an engine works. The air fuel mixture is compressed into the cylinders, which is then ignited by the ignition system. Just one small spark is all that’s necessary to combust this air/fuel mixture and complete the power stroke. So spark is spark right? Well not quite! Most stock ignitions only produce a single weak spark to fire the spark plug. And that may be good enough for a stock engine, but it’s not ideal if you really want to get the most out of your engine's potential.
Supercharged LS Swapped S-10 with Sniper EFI! - Holley LS Fest| 12/20/2018
We spotted Bill Alvis from Tweakin' Perfromance and his nitrous fed LS S-10 Extreme at LS Fest East 2018. In this video, Bill gives us the low down on the S-10 and how the short-block came straight out of his very understanding wife's GTO. Bill runs our Holley Sniper Stealth 4500 EFI on top of a Weiand Supercharger giving it boost, and also runs NOS up to a 100 shot! Check it out!
Holley EFI 12.3" Pro Dash| 01/15/2019
Sema’s Best engineered product just got bigger and better! Holley’s large 12.3” Pro Dash allows you to monitor engine parameters at a glance and custom tune with your finger tips. There’s even a virtual switch panel to control your accessories. The Pro Dash is a must have for any Holley EFI system.
Turbo or AC? - Mark Siders' LS Powered 1963 Volkswagen Beetle - Holley LS Fest| 01/14/2019
Mark Sider had the choice between Turbo or AC on his 1963 Volkswagen Beetle. We think he made the right choice.