- Color: Black
- Horsepower: 350
- Drivetrain: 4x4
1986 CJ7 that my father and I built together 23 years ago in our garage. I was lucky enough to inherit this from him before my parents moved out of state. But this is the project that really sparked my interest in vehicles and the off-road world. As it sits right now, it's a Small Block Chevy with a TH350 transmission and a Dana 300 transfer case. Stock front axle, and a Dana 44 in the rear out of an International Scout. 2.5" suspension lift, with a 2.5" body lift, running on 33x12.50x15 Goodyear Wrangler MT/R tires right now. Honestly, nothing fancy, but she runs good and gets the job done for what she is!
Just Starting Off08/26/2019
The story of this jeep starts off around 25-26 years ago, when my Dad got the itch to start going back up to Silver Lake Sane Dunes after both my sister and I were born. I was about 5 when i got to experience the sand dunes for the first time myself,...
Digging Up the Past09/03/2019
I was just digging through some old boxes of goodies and came across these few photos shortly after we brought the Jeep home and started tearing into it. The original 4 cylinder motor getting ready to be ripped out of this frame and hauled off to nev...
- 10.75 and 11.50-inch bolt circles. 2800-3200 RPM stall
- Universal 3 & 4-speed Compatible Shifter
-Do a YJ leaf spring conversion with OME springs -Remove rear end spool and replace with locker of some sort -Install locker in front end and re-gear both front and rear end with 4.11's -Clean up the dash with new Auto Meter gauges and radio -New seats front and rear with 5 point harnesses for the front -Clean up paint and body work -Install fuel cell with high pressure pump -Install Holley Terminator EFI throttle body kit -Build low compression motor for a Weiand 142 or 177 supercharger -Find another set of paddle tires for the dunes