How to Identify Your Holley or Demon Carburetor
And have you ever tried to determine exactly what carburetor you had but had no idea how to do it? This short, informative video should answer any other questions you have. You'll learn the key to figuring out exactly what carb you have: the list number. It's like a "VIN" for your carburetor and should be hand-stamped on the front of the choke tower to the right of the vent tube on most typical Holley carbs.
The list number typically is four to six digits long and may or may not have a suffix number behind it. The date code will be right below it. Take care not to mistake the casting number and the list number – the casting numbers will be raised (not stamped) and alphanumeric. Invaluable information about the model, CFM, factory jets, power-valve size, and air bleeds can be discovered just by knowing your list number. So spend a few minutes watching this video now and save yourself a lot of time later!
Jeremy Stoermer's AAR Cuda Tribute Car| 02/06/2015
Our very own Jeremy Stoermer was kind enough to share his jaw-dropping 1970 AAR Cuda Tribute car with us. Check out our video to learn more about the car, the story behind it, and to hear that 340 cubic inch Mopar-mill roar!
Holley Announces Tri-Power Systems for Small Block Chevy| 05/07/2015
The Holley Tri-Power setup made famous on big block Corvettes in the 60s has been revived to breathe new life into your small block Chevy-powered Hot Rods!
Holley EFI 12.3" Pro Dash| 01/15/2019
Sema’s Best engineered product just got bigger and better! Holley’s large 12.3” Pro Dash allows you to monitor engine parameters at a glance and custom tune with your finger tips. There’s even a virtual switch panel to control your accessories. The Pro Dash is a must have for any Holley EFI system.
Turbo or AC? - Mark Siders' LS Powered 1963 Volkswagen Beetle - Holley LS Fest| 01/14/2019
Mark Sider had the choice between Turbo or AC on his 1963 Volkswagen Beetle. We think he made the right choice.